when i hatch a file i dont see it right after i logoff in mis like i see when a message is posted. is it be or it would run after some one posts?
when i hatch a file i dont see it right after i logoff in mis like i when a message is posted. is it be or it would run after some one posFiles are hatched when you run the hatch files for MUTIL. Do you have an event set up to run that when new files are detected?
its in my export.ini but it used to or i think it did was see a message
in semaphore and export that. when you have a stroke your not the brightest light in the bunch anymore. ;)
Well it could be any number of things that are broken too..its all good either way! :)
What Mystic should be doing is creating a "filebone.out" file and then
you can create a Semaphore event to run when that file exists. The
event would run your hatch function using MUTIL.
What Mystic should be doing is creating a "filebone.out" file and then
you can create a Semaphore event to run when that file exists. The
event would run your hatch function using MUTIL.
yes it is creating it but if there is echomail.out it runs and will
hatch but if filebone.out is there it just waits for an event or waits
for a echomail.out.
yes it is creating it but if there is echomail.out it runs and will hatch but if filebone.out is there it just waits for an event or wait for a echomail.out.I can confirm this. filebone.out just sits there. it never fires the
event configured for the semaphore filebone.out.
I can confirm this. filebone.out just sits there. it never fires the event configured for the semaphore filebone.out.
i wrote a mpl to fix this. it creates an echomail.out file so it gets tossed. put it in my sysop menu
I can confirm this. filebone.out just sits there. it never fires the event configured for the semaphore filebone.out.
i wrote a mpl to fix this. it creates an echomail.out file so it gets tossed. put it in my sysop menu
I am wondering if there is a misunderstanding of the event system here.
When you create a Semaphore event you then have to tell it what file(s) to look
for. It doesn't trigger automatically for filebone stuff, you have to tell >it to. Can you show what your event looks like?
All of the semaphore events are the same code so if one works then the system >is likely not broken.
--- Mystic BBS v1.12 A37 2017/12/08 (Windows/32)
* Origin: Sector 7 [Mystic BBS WHQ] (21:1/108)
What Mystic should be doing is creating a "filebone.out" file and then
you can create a Semaphore event to run when that file exists. The
event would run your hatch function using MUTIL.
| Sysop: | sneaky |
|---|---|
| Location: | Ashburton,NZ |
| Users: | 31 |
| Nodes: | 8 (0 / 8) |
| Uptime: | 204:06:45 |
| Calls: | 2,083 |
| Calls today: | 1 |
| Files: | 11,139 |
| Messages: | 948,027 |